specification p501 portland cement concrete

Home Products specification p501 portland cement concrete

specification p501 portland cement concrete

SPECIFICATION P-501. PORTLAND CEMENT CONCRETE

2015-2-16 SPECIFICATION P-501. PORTLAND CEMENT CONCRETE PAVEMENT DESCRIPTION 501–1.1 This Work consists of pavement composed of Portland cement concrete, constructed on a prepared underlying surface in accordance with these Specifications and shall conform to the lines, grades, thickness, and typical cross sections shown on the Plans.

REVISED ITEM P-501 - PORTLAND CEMENT CONCRETE

2009-1-5 PROPOSED SPECIFICATION FOR CONCRETE AIRFIELD PAVEMENT 1.0 DESCRIPTION 1.1 General This work shall consist of pavement composed of hydraulic cement concrete, constructed on a prepared underlying surface, in accordance with these specifications and shall conform to the lines, grades, thickness, and typical cross sections shown on the plans.

SPECIFICATION 501 – PORTLAND CEMENT CONCRETE

SPECIFICATION 501 – PORTLAND CEMENT CONCRETE PAVEMENT 321 501-2.07 Proportioning of Concrete a. The Contractor shall design the concrete mix determining the proportions of Portland cement, coarse and fine aggregate, and water necessary to produce a workable concrete meeting the following requirements: 1. A compressive strength of 5,000 psi

ITEM P-501 PORTLAND CEMENT CONCRETE PAVEMENT

2012-3-20 ITEM P-501 PORTLAND CEMENT CONCRETE PAVEMENT DESCRIPTION . 501-1.1 This work shall consist of pavement composed of portland cement concrete, without reinforcement, constructed on a prepared underlying surface according to these specifications and shall conform to the lines, grades, thickness, and typical cross sections shown on the

ITEM P-610 STRUCTURAL PORTLAND CEMENT

2018-3-21 Specification Item P-610, as included and modified hereafter, and as shown on the Plans. ITEM P-610 STRUCTURAL PORTLAND CEMENT CONCRETE . DESCRIPTION 610-1.1 This item shall consist of plain or reinforced structural portland cement concrete, prepared and constructed in accordance with these specifications, at the

MICHIGAN DEPARTMENT OF TRANSPORTATION

2016-2-25 P-501, Portland Cement Concrete Pave ment Page 3 of 19 where the maximum should be less than 6 percent. The use of fly ash as a partial replacement for cement, at the rate specified in paragraph 3.6, will be allowed at the Contractor’s option. (b) Air-Entraining Admixtures. Air-entraining admixtures shall meet the requirements of

03 05 15 - PORTLAND CEMENT CONCRETE

2016-1-16 A. Portland cement concrete shall be composed of portland cement, fine aggregate, coarse aggregate, and water, with or without admixtures as approved by the Engineer, proportioned and mixed as specified herein. 1.07 SUBMITTALS. A. General: Refer to Section 01 33 00, Submittal Procedures, and Section 01 33 23, Shop

03 05 15 - Portland Cement Concrete

2009-10-1 PORTLAND CEMENT CONCRETE RELEASE - R2.1 SECTION 03 05 15 BART FACILITIES STANDARDS Issued: 10/01/2009 PAGE 7 OF 19 STANDARD SPECIFICATIONS 2.01 MATERIALS A. Portland Cement: ASTM C150, Type II, low alkali. Type III portland cement may be used where high early strength concrete is a requirement as approved by the

FAA drafts new concrete pavement specification

501 “Portland Cement Concrete Pavement” and P-110 “Methods of Estimating Percentage of Material Within Specification Limit.” The specifi-cation revisions affect the statistical ac-ceptance criteria for strength and thick-ness. Paving contractors should take particular note of the payment section of the new P-501 specification, which has

PORTLAND CEMENT

2021-3-26 Portland cement is the basic ingredient of concrete. Concrete, one of the most widely used construction materials in the world, is formed when portland cement creates a paste with water that binds with sand and rock to harden. The U.S. industry average portland cement, as found by this study, is 91.4% clinker by weight. Table 1 describes the

SECTION 501 PORTLAND CEMENT CONCRETE PAVEMENT

2014-7-8 501 – PORTLAND CEMENT CONCRETE PAVEMENT 2014 EDITION 212 The conference topics will include equipment, construction methods, specification requirements, and lines of communication. The conference must include the foreman, other Contractor personnel that will supervise the concrete paving operations and key Department inspection personnel.

CONSTRUCTION REQUIREMENTS - Tennessee

2017-10-23 partial cement replacement, to provide Portland cement concrete of the design strengths specified in all applicable special provisions, on the plans, or in the standard specifications. Type I-SM cement or Type I cement with fly ash or ground granulated blast furnace slag as a partial cement

STANDARD CONSTRUCTION SPECIFICATIONS FOR

2019-3-2 The Engineer may require an additional one-half sack of Portland concrete over the design specification. D. Water Water used for the mixing of concrete shall be clean and free of oil or acid, and shall not contain salt, alkali, or organic matter. E. Aggregates Aggregates for Portland Cement Concrete shall be well graded, clean, hard gravel,

03 05 15 - PORTLAND CEMENT CONCRETE

2016-1-16 A. Portland cement concrete shall be composed of portland cement, fine aggregate, coarse aggregate, and water, with or without admixtures as approved by the Engineer, proportioned and mixed as specified herein. 1.07 SUBMITTALS. A. General: Refer to Section 01 33 00, Submittal Procedures, and Section 01 33 23, Shop

PORTLAND CEMENT

2021-3-26 Portland cement is the basic ingredient of concrete. Concrete, one of the most widely used construction materials in the world, is formed when portland cement creates a paste with water that binds with sand and rock to harden. The U.S. industry average portland cement, as found by this study, is 91.4% clinker by weight. Table 1 describes the

Product Specification Sheet - Bulk Concrete

2019-12-19 roct Specification Seet 2 Benefits Versatile basic building material that is suitable for a variety of concrete construction applications Meets ASTM C150 and AASHTO M 85 requirements for Portland cement Depending on project location and cement source, the cement may contribute to regional credits in some green

03 05 15 - Portland Cement Concrete

2009-10-1 PORTLAND CEMENT CONCRETE RELEASE - R2.1 SECTION 03 05 15 BART FACILITIES STANDARDS Issued: 10/01/2009 PAGE 7 OF 19 STANDARD SPECIFICATIONS 2.01 MATERIALS A. Portland Cement: ASTM C150, Type II, low alkali. Type III portland cement may be used where high early strength concrete is a requirement as approved by the

Material Construction Specifications for Concrete ...

• ASTM C150 Standard Specification for Portland Cement • Type I-For use when the special properties specified for any other type are not required. • Type IA -Air-entraining cement for the same uses as Type I, where air -entrainment is desired. • Type II -For general use, more especially when moderate sulfate resistance is desired. • Type IIA -Air-entraining cement for

Section 430 Portland Cement Concrete Pavement

2015-3-12 A. Mix the Concrete Produce Portland cement concrete by combining authorized proportions of materials in batches according to the construction methods in this Specification. Mix the concrete produced in a stationary central mix plant for at least 60 seconds after all materials have entered the drum.

SECTION 0301 PORTLAND CEMENT CONCRETE

2017-12-6 PORTLAND CEMENT CONCRETE 0301.0100 GENERAL 0301.0101 Description of Work. Except as otherwise noted in the special specifications, concrete shall be composed of Portland cement, fine aggregate, coarse aggregate, and water, so proportioned and mixed as to produce a plastic, workable mixture in accordance with all

SECTION 501 PORTLAND CEMENT CONCRETE PAVEMENT

2014-7-8 501 – PORTLAND CEMENT CONCRETE PAVEMENT 2014 EDITION 212 The conference topics will include equipment, construction methods, specification requirements, and lines of communication. The conference must include the foreman, other Contractor personnel that will supervise the concrete paving operations and key Department inspection personnel.

SECTION 501 PORTLAND CEMENT CONC RETE - RTC

2015-6-3 Concrete Institute (ACI) with the following additions and/or exceptions indicated in this specification. B. As used in this section, the term Portland Cement shall be considered synonymous with the term Hydraulic Cement. C. The use of mobile mix concrete as specified herein shall require prior written approval by the Contracting Agency.

ITEM 501.01000001 - PORTLAND CEMENT CONCRETE -

2021-11-18 ITEM 501.01000001 - PORTLAND CEMENT CONCRETE - PERFORMANCE MIXTURE DESIGN AND QUALITY CONTROL Page 3 of 13 Rev Nov. 17, 2021 a. Concrete Sand. The Contractor shall use only sand meeting the requirements of §703-07, Concrete Sand or graded according to ASTM C-33 size designations to optimize aggregate gradation of the

STANDARD CONSTRUCTION SPECIFICATIONS FOR

2019-3-2 The Engineer may require an additional one-half sack of Portland concrete over the design specification. D. Water Water used for the mixing of concrete shall be clean and free of oil or acid, and shall not contain salt, alkali, or organic matter. E. Aggregates Aggregates for Portland Cement Concrete shall be well graded, clean, hard gravel,

Portland Cement Specifications [Types of Portland Cement ...

2021-8-31 The distinct types of portland cement are defined through ASTM C150-21: Standard Specification for Portland Cement, which distinguishes them by purpose. The standard types of portland cement are: Type I – for general purpose. Type IA – same as Type I, but when air entrainment is desired. Type II – for moderate sulfate resistance.

Section 430 Portland Cement Concrete Pavement

2015-3-12 A. Mix the Concrete Produce Portland cement concrete by combining authorized proportions of materials in batches according to the construction methods in this Specification. Mix the concrete produced in a stationary central mix plant for at least 60 seconds after all materials have entered the drum.

Material Construction Specifications for Concrete ...

• ASTM C150 Standard Specification for Portland Cement • Type I-For use when the special properties specified for any other type are not required. • Type IA -Air-entraining cement for the same uses as Type I, where air -entrainment is desired. • Type II -For general use, more especially when moderate sulfate resistance is desired. • Type IIA -Air-entraining cement for

SECTION 0301 PORTLAND CEMENT CONCRETE

2017-12-6 PORTLAND CEMENT CONCRETE 0301.0100 GENERAL 0301.0101 Description of Work. Except as otherwise noted in the special specifications, concrete shall be composed of Portland cement, fine aggregate, coarse aggregate, and water, so proportioned and mixed as to produce a plastic, workable mixture in accordance with all

SPECIFICATION 601 – STRUCTURAL CONCRETE finishing

SPECIFICATION 601 – STRUCTURAL CONCRETE 445 601-1 DESCRIPTION 601-1.01 Scope a. This work shall consist of furnishing, placing, finishing and curing portland cement concrete in bridges, culverts, retaining walls and other structures in accordance with these specifications and in conformity with the lines,

SECTION 09 24 00 - PORTLAND CEMENT PLASTERING

2020-12-14 C150/C150M-20Portland Cement . C206-14Finishing Hydrated Lime. C207-18Hydrated Lime for Masonry Purposes . C260/C260M-10a(2016)Air Entraining Admixtures for Concrete. C847-18Metal Lath . C897-15(2020)Aggregate for JobMixed Portland Cement Based Plasters. C926-20Application of Portland CementBased Plaster